CT4, Tòa nhà Vimeco, Nguyễn Chánh, Cầu Giấy, Hà Nội 
info@sbc-tt.com 
.png)
Textured Paint
Tư vấn sản phẩm
Liên hệ đại lýSP ® ZINS – 710 EPOXY HEAT - RESISANT RICH ZINC PRIMING PAINT
MSP:
Product Description
- Characteristic
- Surface preparation
- Construction
- High adhesion.
- Durable with saline, petroleum, sea water, fresh water, chemicals in pH range 5-9.
- High abrasion resistance.
- High heat resistance. It can be used for heated surfaces up to 400 0C (discontinuous).
- For surface of new untreated steel: Grade of cleanliness is Sa 2.5 (ISO 8501-1: 1998). Mechanical cleaning up to the minimum standard of St2 (ISO 8501-1: 1998) may be acceptable depending on the intended use.
- For temporary primer-coated steel surfaces: The appropriate temporary primer coat surfaces should be clean, dry, free from contamination and free of any foreign matter, such as oil and grease.
- For surface had old painting layer: The appropriate primer must be dry, clean and free from decomposition
- Stir the A part by stirrer. Slowly pour part B into container has part A at a rate of 41 parts A and 59 parts
B.
- Dry Film Thickness Reference:
Use as coating: 75 μm.
Primer for heat-resistant coatings: 30 - 50 μm.
- Use only the recommended solvent (maximum 5% of weight of A & B mix). Mixing should not exceed 6 hours at 23 0C.
| Color: | Gray Zinc |
| Solid content: | Min 75% |
| proportion: | 4 - 6 m 2 / kg / 40μm (depending on surface conditions) |
| Theoretical coverage: | 2.0 ± 0.g/ml |
| Mixing ratio A/B: | 10 / 1 (by volume) |
| Film thickness: | Wet thickness: 70-80 µm Dry thickness: 35-40 µm |
| dried(23°C): | Touchable dry 15-20 minutes Hard dry 2h |
| Time coating layer (23°C): | Minimum after 2h |
| Time live (after mixing): | 5 hours at 25oC |
| Diluent: | P®TN301 |
.png)
.png )
.png&description=SP ® ZINS – 710 EPOXY HEAT - RESISANT RICH ZINC PRIMING PAINT){kind=link}