• CT4, Tòa nhà Vimeco, Nguyễn Chánh, Cầu Giấy, Hà Nội
  • info@sbc-tt.com
    • Tư vấn kỹ thuật sơn: 0934518468 (Ms. Thoa)
    • Tư vấn bán hàng Sơn: 0973883409 (Mr. Quyền)
    • Tư vấn sàn sp deck: 0941460336 (Mr.Ninh)
    • Tư vấn tôn lợp: 0916688189 (Mr. Hiếu)
  • Việt Nam English



Product Description

SP ® LEV is a solvent-free, self-leveling, three-component epoxy resin based floor coating for seamless finish. It can be applied in many different thicknesses depending on the purpose for each floor. It is often used in a wide range of industries ranging from light to medium loads and floors that require long-term protection against chemicals, abrasives such as warehouses, laboratories, factories, industrial factory, hospital.
  • Excellent bearing capacity and abrasion/chemical resistance. Available in wide range of color. 
  • Can be applied at thickness from 1-3 mm (depending on the method of construction).

- Floor requirements: New concrete floors require a minimum of 28 days to fully cure before painting. Minimum moisture content on the surface should not exceed 4%.

  • Ambient moisture content shall not exceed 85%.
  • Concrete marks must comply with concrete standards such as water / cement ratio, additives, minimum cement requirements as well as durability specifications.

- Surface preparation: All types of concretes that are damaged with sticky chemicals and dirty impurities must be completely cleaned. The concrete surface should have a good roughness to ensure good adhesion. Concrete floors should be smooth and clean. Small defects and convex surface should be applied flat to avoid loss of paint.

  • If surface preparation is completed the previous day, it is necessary to vacuum the entire floor.

The best adhesion is obtained when the next coat is applied on the first coat without curing. If the subsequent coating time is exceeded, the surface should be sanded.


  • Part A: liquid. Part B: liquid. Part C: filler
  • Mix each part of A and B to ensure that the mortar does not settle down. Pour carefully, slowly from Part B to Part A, using a slow-speed drill with a suitable stirrer, stirring for at least 3 minutes until uniformly. Pour slowly the C into the mixture. Stir continuously while pouring, ensuring that the particles are mixed and dispersed evenly.
  • Pour the mixture on the primed floor, work quickly with appropriate trowel, apply trowel to adjust the surface of mortar and achieve the desired thickness.
  • The mixture should be used immediately. It shall not be left more than 30 minutes at 230C.
  • SPTHINNER - 305 can be used for thinning if needed, but not more than 2% by volume.

Cleaning tools and equipment after application with SPTHINNER 300 or SPTHINNER 305.

Sản phẩm liên quan

Contact Us

The product you are interested in

Product's name: